Honda cn2\cn3 datalogging connector for obd0\obd1 ecu pinout

connector or cable wiring scheme

Honda`s ECU Pin	Pin Name	Description
1	GND
2	RX	send Data from the PC to the ECU
3	+5V
4	TX	send Data from ECU to the PC
5	NC	Not connected

This port is half-duplex (RX and TX are connected) in stock form. Baudrate is unknown. In modified rom`s it`s use 10 bits 38400 baudrate.

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Want to add or correct something here? Edit this page!

Pinoutsguide.com > Cars and bikes interfaces > Pinout of Honda cn2\cn3 datalogging connector for obd0\obd1 ecu	Is it correct?:	unknown
Source(s) of this and additional information: www.getglitched.com Contributor: Chen	no reports
Last updated 2009-08-29 17:06:20. Edit this page.	Is this document correct or incorrect? What is your opinion?

[Discuss at the forum] [Back to index] [SUBMIT new pinout]

This page contain parts under Copyright © 2000-2009 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.