Hardware connector pinouts cables schematic wiring

Interfaz OBD2 Connector pinout

connector or cable wiring scheme

bookmark this page

In the bus, the bushing is for the connection at the Boardcomputer in the Lenksule about 30cm beneath the steering wheel behind a simple plastic lid. Flight the dimensions determines can go off and then it: I decided on a simple solution, with which material costs in height occur of  2.51. For that one can do handicrafts then to be sure theoretically 10 connectors, for it gives the components only in the 50er bag. 

Pin
 
Pin name Description
1 NC  
2 J1850 bus +  
3 NC  
4 Vehicle mass  
5 Signal mass  
6 CAN High (J-2284)  
7 ISO 9141-2 K exit  
8 NC  
9 NC  
10 J1850 bus  
11    
12    
13    
14 CAN Low (J-2284)  
15 ISO 9141-2 L exit  
16 Battery-tension + 12V  

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Want to add or correct something here? Edit this page!
Pinoutsguide.com > Cars and bikes interfaces > Pinout of Interfaz OBD2 Coonector
Is it correct?:
unknown
Contributor: enigmaelectronica
no reports
Last updated 2010-06-19 20:57:25. Edit this page. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2009 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.