Hardware connector pinouts cables schematic wiring

Mitsubishi old 12 pin diagnostic connector pinout

connector or cable wiring scheme

bookmark this page

used in all Mitsubishi models of 1989-1998's

 

Pin
Number
  Description (may be empty)
1 Engine  MPI - engine control system (yellow), ABS/ASR control (black connector)
2 Steering  4WS - Steering wheel control
3 Suspension  Active ECS
4 Brake  ABS diagnostic (yellow red)
5 Cruise control  ASC diagnostic (yellow black)
6 Transmission  ELC-4/5AT - automatic transmission diagnoetic
7 Air conditioner  Full auto AC - air conditioner diagnostic
8 Air bag  SRS - safety systems
9 ETACS  Pulse signal only - electronic equipment
10 Diagnosis Control Diagnosis control. In 6G72 MPI SOHC, Mirage 1.5L,1.8L short to GND if check and adjust idle or connect the voltmeter positive probe for read DTC ECS (pink blue)
11    Simulation of speed sense
12 GND  Ground (black)

This information should be correct, but may be not. Please, help us to improve this document!
Is this document CORRECT or INCORRECT? Your opinion will be used to establish document status (showed at the bottom).

Want to add or correct something here? Edit this page!
Pinoutsguide.com > Cars and bikes interfaces > Pinout of Mitsubishi old 12 pin diagnostic connector
Is it correct?:
unknown
Contributor: , LDi Garage, LDi Garage
no reports
Last updated 2010-02-27 22:30:50. Edit this page. Is this document correct or incorrect? What is your opinion?
[Discuss at the forum] [Back to index] [SUBMIT new pinout]
This page contain parts under Copyright © 2000-2009 by pinouts.ru team.
No any portion of this webpage may be reproduced in any form without visible direct link to this page provided. Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.