Bookmark /  Обсудить  /  Редактировать  this page or добавить новую.
3 pin stereo plug схематический вид разъема
3 pin stereo plug разъем
at the cable
used in various audio hardware, including computer audiocards

A TRS connector (tip, ring, sleeve) also called an audio jack, phone jack, phone plug, jack plug, stereo plug, mini-jack, mini-stereo, or headphone jack, is a common analog audio connector. It is cylindrical in shape, typically with three contacts, although sometimes with two (a TS connector) or four (a TRRS connector).

It was invented for use in telephone switchboards in the 20th century and is still widely used, both in its original ¼″ (exactly 6.35 mm) size and in miniaturized versions: 3.5 mm (approx. 1/8″) and 2.5 mm (approx. 3/32″). The connector's name is derived from the names of three conducting parts of the plug: Tip, Ring, and Sleeve.

TRS connector typical pinout for audio plug

Name Position Number Most common Colour
L (Left Signal) Tip 1 Green
R (Right Signal) Ring 2 Red
GND (Ground) Sleeve 3 Bare Copper

Some common uses of jack plugs and their matching sockets are:


Color codes of computer soundcard audio jacks

These codes were standardized by Microsoft and Intel in 1999 for computers as part of the PC99 standard. 

green TRS 3.5 mm stereo output, front channels or headphones
black TRS 3.5 mm stereo output, rear channels
grey TRS 3.5 mm stereo output, side channels
gold TRS 3.5 mm dual output, center and subwoofer
blue TRS 3.5 mm stereo input, line level
pink TRS 3.5 mm mono or stereo microphone input


Этот документ правильный или с ошибками?.
There are 57 reports in our database: 53 positive and 2 negative. > Аудио/видео техника > Распиновка 3.5 mm or 6.25 mm Stereo Telephone plug использующего разъем 3 pin stereo plug
This page contain parts under Copyright © 2000-2014 by team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.