Bookmark /  Discuss  /  Edit  this page or submit new.
9 pin D-SUB male connector layout
9 pin D-SUB male connector
at the UPS
8 pin RJ45 (8P8C) female connector layout
8 pin RJ45 (8P8C) female connector
at the Adapter
Should work with APC UPSs that use the following cables: APC Part# 940-0024C, # 940-0024D or 940-1524(black cable) This is to plug a Cisco console (rollover) cable into.

 

UPS
Signal Name		 DB-9 Male
(UPS end)		 RJ45 Female
(Adapter end)		 Adapter
Signal Name
TX 2 3 Rx, Received Data
RX 1 6 Tx, Transmitted Data
Common 9 4 GND

Might be needed in some cases: pins 8,1 (RTS, CTS) shorted.

 

Terminal Set Up:

2400 baud

8 bit no parity

1 stop

no handshake

Press enter until login appears.

Is this document correct or incorrect?.
There are 0 reports in our database: 0 positive and 0 negative.
PinoutsGuide.com > UPS devices pinouts > Pinout of APC Smart UPS cable Adapter pinout
This page contain parts under Copyright © 2000-2011 by pinouts.ru team.
No portion of this webpage may be reproduced in any form without providing visible HTML link to PinoutsGuide.com . Webmaster permission required in any other cases.
Efforts have been made to ensure this page is correct, but it is the responsibility of the user to verify the data is correct for their application.